FROM $1.03 per sq/ftFROM $1.03 per sq/ft
The H profile is special designed for connecting two polycarbonate sheets together on their length side. It must not be screwed, just applied to the two panels. It can be easily cut
It should be applied on the length side of the panel, as shown in pictures. The Polycarbonate H profile is very easy to cut.
FROM $0.50 per sq/ftFROM $0.50 per sq/ft
The U Polycarbonate profile is designed to seal the edge of the polycarbonate sheets. Applied after the solid/vented aluminum tape it close the edge to prevent dust, water and bug get access to the hollow space. It also provide a a clear finish to the edge of the sheet. It can be easily cut
The profile can be easily cut
In order to prevent dust and dirt penetrating inside the ribs, the exposed top and bottom ends (the width side of a sheet) must always be sealed first with the solid aluminum tape on the top and vent tape at the bottom.
As low as FROM $11.43 per sq/ftAs low as FROM $11.43 per sq/ft
The solid tape should be applied on the top width edge of the polycarbonate sheets to prevent water, dust and dirt to get inside the ribs. Different sizes available for panels from 4 to 45mm.
As low as FROM $30.93 per sq/ftAs low as FROM $30.93 per sq/ft
The solid Vented tape should be applied on the bottom width edge of the polycarbonate sheets to allow condensation drainage and prevent dust and dirt to get inside the ribs. Different sizes available for panels from 4 to 45mm.